Use the tool below to determine which liner is the best fit for your herd and plant.

Recommended Liner

Tension Ring

Important Notes:

  1. If no recommendation comes up contact This email address is being protected from spambots. You need JavaScript enabled to view it..
  2. Contact This email address is being protected from spambots. You need JavaScript enabled to view it. for further information if the following applies to you:
    • Tapered shells should have liners trialled first.
    • Some Monokura shells are cut-down. Measure before proceeding with the recommendation.
    • Some Skellerup liners are NOT compatible with ‘stand-up’ type jetters.
  3. Check if a milking liner with a vacuum shut-off groove is needed (only VacPlus Square M22 SO and Reflex M22 SO liners have a shut-off groove).
  4. Jetter Wash Compatibility – Always trial one set of liners for wash system compatibility.